Stainless Steel Couplers for Fiberglass, Round, Solid Rod and Tube.
If using these couplers on another manufacturer’s tubes or rods, pay close attention to the ID and OD of the coupler which is listed once you make a nominal size selection.
Couple the following:
1 inch OD Rods and Tubes
.75 inch OD Rods and Tubes
Designed for use with our Shallow Water Boat Anchor Systems, these hand lathed couplers, are strong enough for any use you can come up with. With their fine threading, they screw together easily, seat together very tightly, and are stronger than the rods and tubes themselves. Rest assured that these will stand the test of time and use.
Step-by-Step Installation Guide
Don’t have a Max-Gain Systems DIY Anchor system? Add capability to your existing anchor!
Follow these steps:
1.) Measure the diameter of your anchor rod
2.) Go to this link Make your current anchor modular
3.) select your rod diameter and Add to your Cart both a Male and Female Coupler
4.) You will need a fine toothed hacksaw OR an abrasive cut off wheel on an angle grinder or in a miter saw. Cut your current anchor about 6 inches below the handle (recommended location) or wherever you would like. (Be sure to make your cut straight)
5.) Use JB Weld Original Cold Weld Formula as shown in this Installation Guide
6.) Allow the epoxy to set and you have made your existing system into a modular system.