Trailer Hitch Mast Mount Kit
They are finally here! Our customer’s have been asking for mounting systems for our Masts for years. After going through many different designs we have developed the most capable mounting system for use with our Masts. These Trailer Hitch Mast Mount Kits include all you would need to mount your mast to your trailer hitch. These kits are available with either a 23 inch Hitch Bar or 10.5 inch Hitch Bar. The 23 inch Hitch Bar will allow you to use your mast with the Tailgate down to operate from, with a SUV hatch open, RV storage door open, and many other uses. The 10.5 inch Hitch Bar is for those who want a hitch mounted mast that has a small profile. All of our hitch bars are cross drilled at the receiver end to allow you to turn the Hitch Mast Mount 90 degrees for storage for easier access to your tailgate, trunk, etc… The optional Tilt mechanism allows for the mast to be tilted over, to rest on something, so you can easily work on the top of your mast without the need for a step ladder.
Support Tube Polymer “Anti-Friction” Bearing – Polymer low friction bearing on an internal shelf allows for hand rotation of your mast when support tube clamp is loosened
Support Tube Coax / Cable Port – Port, located at the base of the support tubes, allows for Coax and Cables to be fed up through the mast protecting the Coax or Cable and allowing for a very clean looking install
Support Tube and Tilt Mechanism – Precision welds and made from as few pieces as possible to increase strength and durability
Hitch Bar Cross Drilled – These hitch bars are cross drilled, where the hitch bar attaches to the trailer hitch, allowing for rotation of the entire mount assembly for storage to get it out of the way when you are not currently using it
Steel Construction – These tubes being made from steel makes for no weak points allowing for additional strength
Laser Cut Slots and Holes – Precision laser cut holes for easy hardware insertion and a perfectly smooth base
Powder Coating – Expertly applied powder coating for maximum durability, life span, and a perfectly smooth finish
Stainless Steel Hardware – All hardware is stainless steel for longevity
The Trailer Hitch Mount uses the following components:
1x Mast Support Tube
1x Tilt Mechanism (optional)
1x Cross Adapter (for use with Tilt Mechanism option)
4x 3/8″ Stainless Steel Bolts (for use with Tilt Mechanism option)
1x Hitch Bar (either 23 inch or 10.5 inch)
2x sets of Stainless, Square, U-Bolt Hardware
(If you did not select the tilt mechanism option, proceed to Step 3)
Attach the Tilt mechanism to the Cross Adapter.
Attach the Tilt Mechanism and Cross Adapter assembly to the end of the hitch bar that DOES NOT have the cross drilled holes.
BE SURE to install the assembly with the T-bolt FACING THE VEHICLE. This will allow the tilt mechanism to operate tilting back behind the vehicle.
Attach the Support Tube to the Hitch Bar Assembly